Plumbing Designer - Indianapolis, IN
Qualifications, skills, and all relevant experience needed for this role can be found in the full description below.
Typical responsibilities
Plumbing system design
- Domestic cold and hot water systems
- Sanitary waste and vent systems
- Storm drainage systems
- Natural gas systems, where applicable
- Specialty plumbing systems such as compressed air, medical gases, or process piping, depending on the project
Perform plumbing calculations
- Fixture-unit calculations
- Domestic water pipe sizing
- Sanitary and storm drainage sizing
- Water pressure/flow calculations
- Pump and equipment sizing
- Hot-water demand and recirculation calculations
- Gas pipe sizing
Develop construction drawings
- Plumbing floor plans
- Enlarged restroom plans
- Plumbing riser diagrams
- Isometric diagrams
- Equipment connection details
- Schedules and plumbing details
- Roof/storm drainage plans when required
Code compliance
- Apply applicable plumbing and building codes
- Check accessibility requirements
- Follow local jurisdiction requirements
- Coordinate requirements for backflow prevention, water heaters, grease interceptors, etc.
MEP coordination
- Coordinate plumbing routing with HVAC ductwork, electrical systems, structure, and architectural layouts
- Identify and resolve clashes
- Coordinate pipe elevations and ceiling-space requirements
Work with architects and structural engineers to determine penetrations and equipment locations
Plumbing Designer in indianapolis at Unknown Company
This position is listed as full time and onsite.